HGL HarmonicGuard Low Capacitance

HarmonicGuard Passive

 

The Newest Addition to our Passive Filter Line.

Our HarmonicGuard Low Capacitance filter (HGL) adds to our line of options for passive filters. The HGL was designed to be generator compatible with 5%THD performance.

The introduction of the HGL addresses concerns of excess capacitance when used with a generator. Excess capacitance can cause problems with the generator. 

  • Causes leading Power Factor
  • Creates over-excitation in a generator
  • It is difficult to control both power factor and harmonics together

The Low Capacitance filter reduces the amount of reactive power and enables lower power, lower cost generators to be used.

HarmonicGuard Passive

 

The HGL filter is built using the same highest quality components as the HGP filter with the same available options.
The HGL will offer:

  • Options for open chassis, Type 1 and Type 3R enclosures
  • Contactor - Can be used to disconnect the tuning circuit.
  • Vibration Pads - Reduces audible noise.
  • Floor Stand - 12” steel feet for Type 3R enclosures 125hp and below.  Units 150 hp and above include provisions for floor mounting.
  • Oilfield Duty - features components designed specifically for oil and gas field applications to handle the additional electrical stress. Designed for cyclical loads these units will be available in Type 3R enclosures and will be for use with HP ranges from 40 to 200HP. 
  • True 100kA SCCR
 

Limits Harmonic Distortion

  • Generator compatible, as low as a 1:1 Generator:HGL power rating
  • Performance of 5% or lower THD at full load with Isc/IL<20
  • Meets IEEE-519 requirements
 

Performance

Before HGL   After HGL
Before HGL   After HGL

 

The HGL not only limits current distortion to less than 5% TDD, it also improves true power factor. Multiple package options will allow TCI customers to choose the right filter configuration for the application. Since every power system is different, harmonic mitigation requirements will differ, and even IEEE limits change based on the system loading characteristics. The HGL product returns the power of choice to the customer, allowing for different configurations to achieve different performance and monitoring results.

 

MINIMUM SYSTEM REQUIREMENTS:

The guaranteed performance levels of this filter will be achieved when the following system conditions are met:

Frequency: 60Hz ± 0.75Hz
System Voltage: Nominal System Voltage (line to line) ±10%
Balanced Line Voltage: Within 0.5%
Background Voltage Distortion: < 0.5% THVD

The input VFD current waveform shall be consistent with that of a VFD with 5% AC line reactance at full load and 5% source impedance.

NOTE: The presence of background voltage distortion will cause motors & other linear loads to draw harmonic currents.
Additional harmonic currents may flow into the HGL filter if there is harmonic voltage distortion already on the system.
 

IEEE Standard 519-2014

Table 2 - Current distortion limits for systems rated 120 V through 69 kV

Maximum harmonic current distortion in percent of IL
Individual harmonic order (odd harmonics) a, b
ISC/IL 3≤h<11 11≤h<17 17≤h<23 23≤h<35 35≤h≤50 TDD
<20c 4.0 2.0 1.5 0.6 0.3 5.0
 20<50 7.0 3.5 2.5 1.0 0.5 8.0
 50<100 10.0 4.5 4.0 1.5 0.7 12.0
 100<1000 12.0 5.5 5.0 2.0 1.0 15.0
 >1000 15.0 7.0 6.0 2.5 1.4 20.0

aEven harmonics are limited to 25% of the odd harmonic limits above.

bCurrent distortions that result in a dc offset, e.g., half-wave converters, are not allowed.

cAll power generation equipment is limited to these values of current distortion, regardless of actual ISC/IL.

where

ISC = maximum short-circuit current at PCC

IL = maximum demand load current (fundamental frequency component) at the PCC under normal load operating conditions

 

 

 

 

Technical Articles

 

Drawings & Schematics

 

Dimensions & Ratings

Standard 480V 60Hz

Contactor 480V 60Hz

 

Standard 600V 60Hz

Contactor 600V 60Hz

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Copyright© 2017 TCI, LLC     Tel. (414) 357-4540     Fax. (414) 357-4484     W132 N10611 Grant Drive, Germantown, WI 53022
This site is powered by the Northwoods Titan Content Management System

FOLLOW US

Follow us on LinkedIn Follow us on YouTube Follow us on Google+